First off I bought mine from here at Amazon through the seller "TDC direct" for under $4 shipped! Great Product! Superb price!
These are crystal clear and lay down great! Let me just say that I have put on 20+ screen protectors such as these and can now get them on quick and easy with no air bubbles or particles under it, in fact you cannot tell they are even on there when I'm done! I have found that first it starts with a good product like these, then its all in the application! I use a very simple method using filtered water ( straight out of the pure drinking water filter) and here is how I do it.
Perfect results Installation:
Step #1 Wash your hands and the area where your working by wiping down and making sure its clear of any animal hair, lint, dust etc.
Step #2 Rinse a container large enough to fit your protector in submerged and fill with filtered water (like a plastic glad container)
Step #3 Get everything your using for the instal including the protector and product wiped down with a damp cloth (like a well rinsed dish cloth)
Step #4 Next rinse your hands really well under the sink and again with a little filtered water.
Step #5 Using the filtered water on your damp hands rinse the screen on your product (if it has any skin oil or is dirty use a drop of dish soap first and rinse repeatedly then start again at the top) do this like your swiping like a windshield wiper (don't worry about a little water on you device it wont hurt it!)
Step #6 Next: There are three layers of plastic on each protector the first labeled "step one" take of now, it is the bottom throw away layer! and then use the filtered water in container to rinse the protector just like you did the product screen but this time you can fully submerge the protector to make sure you have cleared any dust or particles from it making sure the bottom surface is absolutely clean by using a wiping motion with your hand repeatedly.
Step #7 Apply filtered water to your now cleaned product screen with your damp hand and with the protector dripping wet straight out of the water set it on to your device and center it. next use a squeegee working your way from the center out pushing the water and air out (i use a little rubber squeegee to do this but a thin peace of plastic with a straight smooth edge like a battery cover off a TV remote works just as good)
Step #8 If you screw up and there is something under the protector like a peace of lint or particle or its not on straight, don't worry just take it off and start over by washing thoroughly and re-applying it as many times as it takes making sure to rinse and fallow the above steps again, these protectors are fully reusable! You can even go back and fix an old application using this method.
Step #9 Make sure you get all the air and water pushed out the best you can. If you can see a tiny water bubble or two don't worry, it will evaporate after a couple days. FYI: Stubborn air bubbles I have found are usually lint or a particle and require a redo.
Step #10 Carefully pull the top protective layer of plastic off leaving the center thicker protector in place. Next dry everything and your done! Shweew you did it! :). Again remember there are three layers to each protector the bottom and top are thinner and get thrown away they are just there to keep the middle "Screen protector" clean.
Sounds like allot LOL but it really is simple if you just get and keep everything clean.
Hope that helps.
PS: With a sharp pare of scissors you can cut the extra two protectors into screen protectors for your camera, phone or whatever... just make sure when you cut, that you hold them bottom side of the protector down and also mark (a thin sharpie marker works good) top/bottom before you cut ;)
| Standing screen display size | 7.9 Inches |
|---|
